Rancang Bangun Sistem Supervisi Scada dan Komunikasi ModbusRtu pada Trainer Filling dan Capping Berbasis Plc Outseal

Authors

  • Zulwisli Zulwisli Universitas Negeri Padang
  • Winda Agustiarmi Universitas Negeri Padang
  • Ryan Fikri Universitas Negeri Padang
  • Gilang Febrian Universitas Negeri Padang

DOI:

https://doi.org/10.61722/jipm.v4i6.3342

Keywords:

SCADA, VTScada, Outseal PLC, Modbus RTU, Human Machine Interface

Abstract

The development of industrial automation requires a centralized monitoring and control system to improve efficiency and occupational safety. This research aims to design and implement a Supervisory Control and Data Acquisition (SCADA) system on a prototype of water bottle filling and capping machine. The local control system is implemented using an Outseal Nano V5 Programmable Logic Controller (PLC), while the Human Machine Interface (HMI) in the control room is developed using VTScada software. The method used in this research is Research and Development (R&D) with a descriptive qualitative evaluation approach utilizing black-box testing. Data transmission between the supervisory layer and the field layer is bridged by the Modbus RTU protocol via RS485 serial communication. The test results indicate that the communication architecture runs highly stable at a Baud rate of 19200 bps without any packet loss. The dynamic Piping and Instrumentation Diagram (P&ID) based HMI successfully visualizes discrete sensor statuses instantaneously and displays fluid volume measurements in real-time from the Holding Register memory. Furthermore, the remote control function is proven to operate precisely, allowing the operator to safely override the machine's operation system remotely.

References

Bolton, W. (2015). Programmable Logic Controllers (6th ed.). Oxford: Elsevier Newnes.

Boyer, S. A. (2009). SCADA: Supervisory Control and Data Acquisition (4th ed.). North Carolina: International Society of Automation.

Prasetyo, M. R. E., Abidin, Z., & Laksono, A. B. (2025). Rancang Bangun Overhead Crane Berbasis PLC Outseal Menggunakan Control Scada. Jurnal FORTECH, 6(2), 80-86.

Setiawan, I. (2006). Programmable Logic Controller (PLC) dan Teknik Perancangan Sistem Kontrol. Yogyakarta: Andi Publisher.

Wicaksono, T., & Sukir. (2021). Pengembangan Automatic Bottle Filling and Capping Machine Sebagai Media Pembelajaran PLC. Jurnal Pendidikan Teknik Mekatronika, 11(2).

Downloads

Published

2026-11-11

How to Cite

Zulwisli Zulwisli, Winda Agustiarmi, Ryan Fikri, & Gilang Febrian. (2026). Rancang Bangun Sistem Supervisi Scada dan Komunikasi ModbusRtu pada Trainer Filling dan Capping Berbasis Plc Outseal. JURNAL ILMIAH PENELITIAN MAHASISWA, 4(6), 1556–1565. https://doi.org/10.61722/jipm.v4i6.3342

Issue

Section

##section.default.title##

Similar Articles

<< < 2 3 4 5 6 7 8 9 10 11 > >> 

You may also start an advanced similarity search for this article.